Gunakan panduan ini untuk memadam atau menggantikan pemacu keadaan pepejal (SSD) di MacBook Pro 13 "Retina Display Early 2015.
Step 1 Lower Case
Remove the following ten screws securing the lower case to the upper case:
- Two 2.3 mm Pentalobe screws
- Eight 3.0 mm Pentalobe screws
Step 2
- Wedge your fingers between the upper case and the lower case.
- Gently pull the lower case away from the upper case to remove it.
Step 3
- The lower case is connected to the upper case with two plastic clips near its center.
- During reassembly, gently push down the center of the lower case to reattach the two plastic clips.
Step 4 Battery Connector
If necessary, remove the plastic cover adhered to the battery contact board.
- Use the flat end of a spudger to lift the battery connector straight up out of its socket on the logic board.
Step 5
Remove the single 2.9 mm T5 Torx screw securing the SSD to the logic board.
Step 6
- Lift the free end of the SSD up slightly and pull the SSD straight out of its socket on the logic board.
Semoga tips ini dapat membantu anda.
Jangan lupa share ya.
Anda ada masalah dengan MacBook/Laptop/Iphone?
Slow
Rosak
Serangan Virus
Jangan risau!!
Kami boleh bantu menyelesaikan masalah anda..
Tak tahu dimana lokasi
MACNOTE STUDIO UIA Gombak?
Anda boleh hubungi kami melalui:
· WhatsApp Abang M
· Facebook Macnote studio
· Careline 013 531 6110
Lot 1 As-Souq At-Tullab ,Mahallah Ali Ibn Talib,
International Islamic University Malaysia,
Universiti Islam Antarabangsa,
53100 Jalan Gombak,
Wilayah Persekutuan Kuala Lumpur
Google Maps : Macnote Mobile
E-mail : macbookstation@gmail.com
Waktu Operasi : Isnin - Ahad (10 a.m. - 9 p.m.) Setiap Hari
Anda boleh datang terus ke MACNOTE di UIA Gombak:
1. KAMI DI GOMBAK ( DALAM UIA GOMBAK)
- 15 MINIT DARI KEPONG DAN SELAYANG
- 25 MINIT DARI BANGSAR DAN AMPANG
- 30 MINIT DARI SETAPAK DAN SENTUL
-40 MINIT DARI PUCHONG DAMANSARA DAN CHERAS
Tiada ulasan:
Catat Ulasan